ERM (Embedded Reservoir Model)ΒΆ

The ERM modules form a workflow that goes from a digital elevation model and the measurements of meteo stations and stream gauges, to a calibrated simulation of the discharge of a basin. The seven steps run in order, each one adding its results to a single GeoFrame database (a GeoPackage), which is the input of the next step:

Step

Module

Adds to the database

1

ErmDataPreparator

the sub-basins (hydrological response units), the network and their topology, the stream gauges

2

ErmStationDataImporter

the measured temperature, precipitation and discharge

3

ErmKriging

the temperature and precipitation of each sub-basin

4

ErmRadiation

the net radiation of each sub-basin

5

ErmPrestleyEt

the potential evapotranspiration of each sub-basin

6

ErmCalibration

nothing: the best model parameters are reported in the log

7

ErmSimulation

the simulated discharge of each sub-basin, in a new table for each run, also shown against the observed one in a chart

Where the meteo stations are too few, the steps 3 to 5 can be replaced by ErmCopernicusImporter, which takes the temperature, precipitation and evapotranspiration of the sub-basins from the daily AgERA5 data of Copernicus. The stream gauges of step 2 are still needed, for the observed discharge.

The modules can be run from the Spatial Toolbox, in the GeoFrame folder, or with scripts in the Geoscript Console. The page of each module has the script of its step: together they are a complete run on a basin in Japan, and only the workspace folder at the top of each script needs to be changed to run them on other data.

TODO

References for the ERM model and the GEOframe environment are still to be added.